Your shopping cart is empty!
Standard LED 3mm diameter.
Connections:
The longer of the 2 leads is the Anode, this MUST be connected to the + (Positive) side of the Supply.
The shorter of the 2 leads is the Cathode, this MUST be connected to the - (Negative) side of the Supply.
PLEASE NOTE:
All LEDs are tested prior to dispatch.
If a supply voltage greater than the rated forward voltage of the LED is to be used,
then a suitable resistor MUST be wired in series with the LED as shown below.
A suitable series resistor is available HERE please refer to the table below:-
These cookies are required for the website to run and cannot be switched off.
These cookies are usually set by our marketing and advertising partners.
These cookies allow us to measure visitors traffic and see traffic sources by collecting information in data sets.