This is a 4 plank wagon measuring 152mm long (165mm over buffers) by 84mm wide and 70mm high above the rails with an 80mm wheelbase.Complete with 3D printed detailing parts, an optional coal load is availible.Download the build instructions..
This is a kit to convert our standard range of quarry rolling stock to brass bearing axle boxes. The axle boxes are slightly larger than the standard ones to accomadate the flange on the brass bearing. The kit includes:-4 brass bearings4 replacement axle boxesAssemble by pressing the bearings in fro..
Barrel wagon 106mm Long x 52mm Wide x 65mm High.This kit is supplied without brass axle bearings but they are available with replacement axle boxes as an option.Please Note: This kit consists of a quarry flat wagon RA-WA-002 and 2 white Oil Drums RA-WL-010, because of this I have only included ..
This is a long flat bed bogie wagon with optional end pieces, measuring 312mm long (340mm over buffers) by 90mm wide and 38mm high above the rails (58mm with the optional end pieces).The bogies are available separately as a home builder part.Please Note that the build instructions are in 2 parts.Dow..
Bolster wagons were used as a pair to carry long loads with either a chain or a draw bar coupling the wagons together.Sold as a pair of wagons they are each 106mm Long x 52mm Wide x 70mm High.This kit is supplied without brass axle bearings but they are available with replacement axle boxes as an op..
A range of low cost bogies, supplied as a pair, with a choice of options available :-48mm wheelbase with 20mm wheels58mm wheelbase with 24mm wheelsMade from laser cut 3mm Ply, 3D printed side frames, Binnie Engineering wheels, steel axles, brass bearings and with a 4mm dia. mount..
This is a Case for QRP Labs QLG1 GPS Receiver. Made from clear laser cut acrylic.Parts Included are:-6 Laser Cut Parts 4 M3 Nuts and Bolts4 M3 Bolts to mount the QLG14 Rubber Feet1 Sleeve GrommetEngraved CallsignPlease Note that the laser cut parts have a clear plastic film on..